Product Data Sheet Show all documents

Sikadur® AP

All purpose epoxy adhesive paste

Sikadur® AP is an all purpose, two component, epoxy paste adhesive

  • Easy to mix and apply
  • Components of different colours to ensure thorough mixing
  • Convenient 1 to 1 mixing ratio
  • Excellent adhesion
  • Can be applied to damp surfaces
  • Ideal for vertical and overhead applications
  • High abrasion resistance
  • Can be smoothed off with water
Product Data Sheet Show all documents

Usage

Sikadur® AP is used for general bonding and patching of a wide variety of materials such as:
  • Brick
  • Concrete
  • Wood
  • Ceramic
  • Metal
 

Advantages

  • Easy to mix and apply
  • Components of different colours to ensure thorough mixing
  • Convenient 1 to 1 mixing ratio
  • Excellent adhesion
  • Can be applied to damp surfaces
  • Ideal for vertical and overhead applications
  • High abrasion resistance
  • Can be smoothed off with water

Packaging

250ml, 500ml and 1litre

Colour

Component A: white

Component B: Light Brown

Components A+B mixed: Beige

Product Details

Product Information

Composition

Epoxy Resin

Shelf life

12 months from date of production

Storage conditions

Store in original, unopened, sealed and undamaged packaging in dry conditions at temperatures between +5 °C and +30 °C. Protect from direct sunlight.

Density

1.7kg/litre (mixed)
Technical Information

Compressive strength

50.0Mpa at 16 hours (23ºC)       

80.0Mpa at 14 Days (23ºC)

Tensile adhesion strength

Concrete: 2-3N/mm2 (concrete failure)

Steel: 9N/mm2

Application

Application Information

Mixing ratio

1:1 by volume: A component is to B component

Ambient air temperature

Min. 5°C – Max. 35°C.

Relative air humidity

80%

Dew point

Substrate temperature must always be at least 3°C above the dew point.

Substrate temperature

Min. 5°C – Max. 30°C.
Application steps

SUBSTRATE QUALITY

The concrete substrate, must be sound and of sufficient compressive strength (min. 20 N/mm² (MPa) with a minimum pull off strength of 1.5 N/mm² (Mpa)).

SUBSTRATE PREPARATION

Requirements:
Substrate must be sound, clean, free from oil and grease, old coatings and surface treatments, etc.
Pre-treatment for good bond:
Concrete, mortar, stone should be thoroughly prepared by high pressure water jetting or mechanical means such as grinding, chiselling etc. Cracks must be cleaned to remove dust with compressed air.

MIXING

Proportion equal amounts by volume of both components into a suitable, clean mixing container. Depending on the volume, mix thoroughly using a large spatula or a slow speed drill (set at 400 - 600 rpm) with a clean, rust free, mixing paddle until the two components are evenly blended to a uniform colour (minimum 3 minutes). Use immediately.

 

Documents